Here's an unfinished photo of what I did. Not sure if you would call it "frenched in". I just cut enough frame out to put the front edge basically flush with the frame.
![](http://i33.photobucket.com/albums/d56/ekibi/IMG_1362.jpg)
I got the rear axle in with the ubolt flip done and I'm super happy with how soft the chevy springs are!! But I'm saggy in the rear, bad.
![](http://i33.photobucket.com/albums/d56/ekibi/IMG_1363-1.jpg)
I'll add another pic later. I should've put the front in there too. The front is easily 3-4 inches higher... Other than blocks.. Any ideas?