Thanks everyone for the complements.
Well here is where I stand. I got the front axle under the rig and I started planning how I was going to mount that bigass trianulated link bracket under the transfercase without loosing 3"+ of belly pan clearance. I cut out the tranny tunnel out on the floor pan to raise the Tcases a few inches into the body but I still wasn't happy with the loss of belly pan clearance. So I decided to use the triangulated link bracket for the rear. I built the cross member out of 2"x.25" wall tubing. As far as the front link set up I am still going double triangulated but it will be a little different design than most. I'll keep you updated.
Thanks
![](http://i999.photobucket.com/albums/af113/jprusso89/20140413_151417.jpg)
![](http://i999.photobucket.com/albums/af113/jprusso89/20140430_201430.jpg)
![](http://i999.photobucket.com/albums/af113/jprusso89/20140503_1252140.jpg)