well i got it with high steer, i think its a TG kit, it has TG springs and TG knuckle bearings, tg axle truss and armor., i already ordered the knuckle sandwich from tg and they sent the same no name , im assuming chinese bearings i already had in it, so i wasnt sure if those would be strong enough, im on 38" swampers. if anyone had just the stock oem bearing number i could probably go to a bearing place. also i heard theres a heavy duty timken bearing instead.
so if this is a TG steering arm then i have to run TG bearings? where can i measure the steering arms?
i was going to have the knuckles and arms machined for 9/16 studs and cone washers. can i also machine it to fit oem bearings?
im still new and learning , i know this is a marlin board but thanks for the help.