« on: Jul 12, 2013, 05:23:07 PM »
Not really sure what your up to? Are you trying to keep the speed sensor for the TCU or are you wanting the speedo to work? These are two different sensors, one is in the trans and the other is in the t-case. I run duals behind an A340f and all I did was bolt on Marlin adapters and buy a speedo extension cable which connected to the rear case just like stock. Marlin sells the adapter to allow electric speedos to work if needed.
There is a build thread here and on Pirate.
I am currently gathering parts for the A340F conversion from the A340E in my 2003 Reg cab stepside Pre runner. So far, I am awaiting shipment on the trans minus bell housing and torque converter. I will be adding this:
http://www.marlincrawler.com/transfer-case/line-ups/single/gear-drive-left-hand-output-leftyI have the 2.7 motor and my question is, will I need a different flex plate & starter?
Thanks.
![](https://board.marlincrawler.com/Themes/MCI_V3C/images/ip.gif)
Logged
'03 Step side Pre-runner, F/R 4WU 3 linked, F/R Diamond axles, F/R ARB's w/5.29's, F/R Fox 12" CO's, ShrockWorks front bumper, self made rear bumper, WARN M8000S w/ remote, 4.7 Inchworm Lefty, MC sliders that hold air & a bunch of other stuff.