Got a little more work done monday night.

cut the diff cover off and assembled the knuckles and spindles to check the shafts spline engagement. i have to move the long side out about a 1/4". i also mocked up a quick tie rod to keep the knuckles strait. not the final configuration i dont think but makes it look more complete. I am going to throw the IFS hubs on after moving the long side out some to get a overall width measurement.




finally unwrapped these bad boys that have been sitting in my tool box for about 4 years,


also picked up these 31's so i could put some miles on the t100 while i keep building the axles: