Author Topic: 20R head, ported big valves and side draft carbs  (Read 340 times)

0 Members and 1 Guest are viewing this topic.

sirdeuce

  • Reputation: (+2)
  • Offline Rock Master
  • ***
  • Turtle Points: 148
  • Male Posts: 257
  • Member since Sep '06
  • One shot, one kill.
20R head, ported big valves and side draft carbs
« on: May 06, 2019, 10:59:15 AM »
I'll put this up again. I have a 20R head with oversize stainless valves and bronze guides with Buick springs. With the head is a set of 40mm DHLA Dell'orto carbs with a Mikuni short manifold. Manifold was matched to this head, and the carbs come with extra jets, E-tubes and chokes to help with tuning and rebuild kits. Has a Mallory pump and regulator with the set. I'll put my jet reamers and gauges in there as well. Bagged and boxed. Also have a Schneider cam, 250-260F. If memory serves me well it's 250 in 260 ex with .470" lift. Check the site for specifics. It's been a shelfed project for quite some time, and I don't think I'll ever get to it.
$1650 for the lot plus whatever shipping would be, if needed. Located in Fresno CA area.
Sure it'll fit........ Just needs a little brute finesse.

sirdeuce [OP]

  • Reputation: (+2)
  • Offline Rock Master
  • ***
  • Turtle Points: 148
  • Male Posts: 257
  • Member since Sep '06
  • One shot, one kill.
I would sell the carbs separately, thinking of a project with the head.
Sure it'll fit........ Just needs a little brute finesse.

 
 
 
 
 

Related Topics

7 Replies
3306 Views
Last post Feb 27, 2005, 12:03:49 PM
by BigMike
6 Replies
4213 Views
Last post Jun 13, 2013, 08:23:06 AM
by sirdeuce
1 Replies
535 Views
Last post Mar 07, 2014, 01:14:40 PM
by sirdeuce
2 Replies
798 Views
Last post Feb 25, 2014, 08:23:36 AM
by sirdeuce
0 Replies
267 Views
Last post Jun 11, 2019, 07:55:03 PM
by sirdeuce