Author Topic: Issues installing gear ring on yukon air locker  (Read 738 times)

0 Members and 1 Guest are viewing this topic.

olyredrunn

  • Offline Dusty Trails
  • *
  • Turtle Points: 0
  • Posts: 3
  • Member since May '17
  • Crawling with Marlin
Issues installing gear ring on yukon air locker
« on: Nov 04, 2017, 05:36:49 PM »
Everything has gone pretty smoothly until I tried installing the new ring on the locker. It just won't go on. I have 2 kits and have tried combinations of rings and lockers thinking maybe there was an issue with one of them and have the same problem every way. It has been oiled, warmed up the ring hoping for it to expand a little, hit it with a mallet...no luck. All of the install videos I've watched the ring basically fell right on. Maybe a couple taps on it if it stuck a bit.

Any tips?

gnob

  • Online Crawler Guru
  • ****
  • Turtle Points: 415
  • Posts: 711
  • Member since May '02
Put locker in freezer. heat gear. Itll geaux.  ;)
hold this. . .

knapp870

  • Offline Rock Crawl'n
  • **
  • Turtle Points: 0
  • Posts: 13
  • Member since Oct '17
  • Crawling with Marlin
I just went through this and mine basically fell on. However I know arbs are often a light press. Make sure it's going down evenly

knapp870

  • Offline Rock Crawl'n
  • **
  • Turtle Points: 0
  • Posts: 13
  • Member since Oct '17
  • Crawling with Marlin
I will say probably the most crucial thing is to not tweak the copper air line out of the metal collar. That caused me hours of issues trying to solder it back air tight

 
 
 
 
 

Related Topics

18 Replies
3726 Views
Last post Jun 26, 2006, 11:07:27 PM
by Doc Holiday
7 Replies
1538 Views
Last post Jan 25, 2010, 03:13:14 PM
by 80YOTA4X4
5 Replies
2040 Views
Last post Mar 21, 2011, 08:28:56 AM
by 1slowhatch
6 Replies
1478 Views
Last post Jan 11, 2012, 08:18:11 PM
by Jaysen
65 Replies
5444 Views
Last post Feb 05, 2015, 06:36:11 PM
by flhtom