Author Topic: Toybrota's 22R build  (Read 35812 times)

0 Members and 3 Guests are viewing this topic.

Toybrota

  • Offline 4WD Legend
  • *****
  • Turtle Points: 121
  • Male Posts: 751
  • Member since Dec '15
  • Crawling with Marlin
    • Buy me some coffee
Re: Toybrota's 22R build
« Reply #540 on: Apr 15, 2019, 08:40:49 PM »
That plate and a leak would drive me nuts.

Not being able see it, I'm guessing the mating surface at the manifold is very narrow?

The amount surface area to seal the plate to the bottom of the manifold is minimal, so with the heat and pressure on the sealing areas, I'd go with whatever Offenhauser recommends.  If there are any defects, Offenhauser should warrantee their stuff.

Gnarls.
I received an email from Tony at LCE. He had this to say about the surfaces: "We actually get these straight from the foundry quite rough.
Offy finish is horrible, so we do it here."
This means they resurface the intake at their shop, I'm assuming this applies to the bottom water plate as well.

I explained the methods I had used to seal it, and he was surprised. He recommended this: "If a gasket is giving you this much trouble, I would get a tube of Hi Temp Copper RTV Silicone 
Gasket Maker and use that with no gasket. I've used Ultra Grey with no issue, but Copper is called for coolant."
I think if the stop leak doesn't work, I'll try this. Coupled with the thread sealant you recommended.
It appears to be still leaking currently, but they say it takes up to 200 miles to seal. If it doesn't seal I'll do the aforementioned.


Crazy thought, what if I made a CNC machined intake for this truck? Two halves, completely custom. Only ports that I need. Ideas...


Sent from my PH-1 using Tapatalk


 
 
 
 
 

Related Topics

9 Replies
4880 Views
Last post Dec 19, 2006, 06:05:03 AM
by yotadork83
1 Replies
2080 Views
Last post Jan 20, 2007, 10:13:46 AM
by toyhunter
48 Replies
18663 Views
Last post Nov 30, 2015, 01:11:55 PM
by Kaos III%
23 Replies
7850 Views
Last post May 16, 2013, 10:49:38 PM
by 88_YotaCrawler_88
40 Replies
25867 Views
Last post Apr 04, 2015, 11:20:52 PM
by Jason E.