Topic: any xr10's out there?

[patches]

i got one.  Havent broken anything except the rear diff gear that the axles go into.twice.  It sure does get old breaking those.  Ill post pics up when im at 11 posts


so does anyone have an xr10?  Would like to see some pics!

[patches [OP]]

heres mine before i had rock chisels all the way around

[Hamsters83]

Lots of upgrades, well over 1100$ invested

[86rustbucket]

^ very nice.     Here's mine.


 

[patches [OP]]

Mine looks all lame compared to you guys haha. Too bad it's broken right now.

[Hamsters83]

What did you break.. Tranmisssion gears ?

[86rustbucket]

i got one.  Havent broken anything except the rear diff gear that the axles go into.twice.  It sure does get old breaking those.  Ill post pics up when im at 11 posts


so does anyone have an xr10?  Would like to see some pics!

I broke one of those. I replaced it with the machined gear from CKRC. They're a little pricy but those stock gears are so easy to break and such a pregnant dog to change.

[patches [OP]]

Transmission gear once and the final drive gear once. And bearings inside the tranny

[Hamsters83]

Yeah I deff hear you on that I changed all mine to RC4WD gears. I had actually shimmed the main drive bearings in the axel to bring the gear pitch closer on those final drive gears. When you get it apart and install the new gear, take a piece of plain printer paper and cut two little thin pieces off it that are the same width of the bearings. With a little dab of glue, glue them to where the bearing sits in the axel, then place the bearings on top an slap it all together .  Works perfect

[Hamsters83]

The first time I blew the gears on my XR, I sent shrapnel threw the axel hahaha I was stunned.

[Rockcrawlintoy]

[Rockcrawlintoy]

some mayhem engineering rims i picked up from a friend

[KDRproductions]

 
I got one of these as wel!!!